Page 1 of 1

Thank you

PostPosted: Tue Jan 15, 2013 5:13 am
by whywhy
Peter,

I just want say thank you for your technical support. Very appreciate it.

Re: Thank you

PostPosted: Tue Jan 15, 2013 7:09 am
by peter
Hi,
thank you!
It's a pleasure to help!

Thank you for using cocoOS! Please let me know what you think about cocoOS, it helps me to make it better.
You are also welcome to mail me at info@cocoos.net

/peter

Re: Thank you

PostPosted: Tue Aug 04, 2015 6:53 am
by FxDev
Hello and thanks to you guys!
Your job is amazing and I know really hard too.

I used your CocoOS with STM8/STM32/Atmel and Microchip microcontrollers especially PIC18Fxx. It's very easy to port and use.

I have a personal blog page (in Turkish) and I will tell about you and your projects to my colleague in Turkey!
I hope it will be good for you!

Re: Thank you

PostPosted: Sat Oct 31, 2015 1:49 am
by nettercm
Hey - just wanted to drop off a thank you note! Keep up the good work!

Have been using cocoOS on my robot for around 2 years now. Why:
* its small
* it doesn't disable interrupts (I have interrupt driven code and the exact time at which I get the interrupt matters)
* it is super easy to port and so I was able to get it up and running on my Atmega1284P Pololu Orangutan SVP-1284 in no time
* I do all my development and initial debugging of my robot logic under windows and because this doesn't mess around with the stack, I was able to port it to windows in no time

I'm using version 3.x. Can you summarize the changes that went into 4.0?